Home | Contact  
ICAA
Members Only Consumer Information Technical Information Join ICAA ICAA Convention and Trade Show
Builders and Code Officials

ASTM E 84-05 Standard Test Method for Surface Burning Characteristics of Building Materials

Extracted, with permission from ASTM E 84-05 Standard Test Method for Surface Burning Characteristics of Building Materials, © ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428. A copy of the complete standard may be purchased from ASTM International, phone: 610-832-9585, fax: 610-832-9555, e-mail: service@astm.org, website:www.astm.org.

Document Summary
© 2005 ASTM International. All rights reserved.

ASTM E 84-05 Standard Test Method for Surface Burning Characteristics of Building Materials
Developed by Subcommittee: E05.22
See Related Work by this Subcommittee
Adoptions: DOD Adopted; Building Codes; ANSI Approved Book of Standards Volume: 04.07

1. Scope

1.1 This fire-test-response standard for the comparative surface burning behavior of building materials is applicable to exposed surfaces such as walls and ceilings. The test is conducted with the specimen in the ceiling position with the surface to be evaluated exposed face down to the ignition source. The material, product, or assembly shall be capable of being mounted in the test position during the test. Thus, the specimen shall either be self-supporting by its own structural quality, held in place by added supports along the test surface, or secured from the back side.

1.2 The purpose of this test method is to determine the relative burning behavior of the material by observing the flame spread along the specimen. Flame spread and smoke developed index are reported. However, there is not necessarily a relationship between these two measurements.

1.3 The use of supporting materials on the underside of the test specimen has the ability to lower the flame spread index from those which might be obtained if the specimen could be tested without such support. These test results do not necessarily relate to indices obtained by testing materials without such support.

1.4 Testing of materials that melt, drip, or delaminate to such a degree that the continuity of the flame front is destroyed, results in low flame spread indices that do not relate directly to indices obtained by testing materials that remain in place.

1.5 The values stated in inch-pound units are to be regarded as the standard.

1.6 The text of this standard references notes and footnotes that provide explanatory information. These notes and footnotes, excluding those in tables and figures, shall not be considered as requirements of the standard.

1.7 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire-hazard or fire-risk assessment of the materials, products, or assemblies under actual fire conditions.

1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


Members Only - Buyer's Guide & Contractor Locator - Technical Information - Join ICAA - ICAA Convention and Trade Show